White Indoor / Outdoor Portable Air Purifier Filter With Electrostatic Generator

Specifications:

Introduction:

Negative ions are considered the “vitamin of the air”. Molecules usually carry a neutral charge; however, when molecules lose an electron, they become anions (negatively charged ions). Anions are relatively unstable, and will attract and trap any free electron pairs. As a result of this attraction, small air pollutants and dust molecules bind with anions, producing an air purifying effect.

The EP100 is a lightweight, easy to carry, and powerful device, which is suitable for both indoor and outdoor use. A high voltage sine wave applied to two stainless steel pins generates negative ions. These negative ions are relatively free from harmful NOx molecules, unlike the ions produced from using high voltage pulses. Because of the sine waveform used, the device gives minimal interference to nearby electronic appliances. This product has CE certification.

The package:

There are five items in the gift-box:

1. The unit with an attached neck strap
2. The mounting base
3. 2×AA alkaline batteries
4. Switching mode power adaptor or AC/DC linear adaptor
5. The instruction manual

How to install the batteries:

When the batteries are used up, please follow the instructions below to change the two AA alkaline batteries
1.       First open one battery cover
2.       Insert a new battery in accordance with the +/- signs marked at the base of the device.

3.       Using the diagram below as a guide, replace the battery cap by aligning the black dot(s) on the cap with the dot(s) labeled “1” 

4.       Twist the cap in the direction of the arrow until the dot(s) align with the dot(s) marked “2”
5.       Repeat steps 1-4 for the other battery
6.       When taking out the battery, twist the cap in the opposite direction. (Caution: If twisted in the wrong direction, the groove inside the battery cap may break, and the entire outer shell will be damaged.)

Operation:

After fitting the batteries, press the ON/OFF button to switch ON the unit, as indicated by a flashing neon light and the production of static wind at the output holes. Hold the button for about 2 seconds to switch the unit OFF.

A set of batteries should last for about 20 hours of use. When the speed of the flashing neon slows down, the batteries should be replaced.

In addition to outdoor use, it is recommended the unit be used indoors with the AC/DC adaptor supplied.

Specifications:

• High voltage of about -8kV
• Stainless steel pin electrodes
• Power consumption:<65mA  at 3V D.C
• Flashing neon light to indicate power status
• Ultrasonic frequency waves about 30 kHz.
• Effective area 15-20(100-150 ft sp)
• Dimension: 102×76×28mm

Important:

This unit must be used with either two AA alkaline batteries or with the switching mode power supply which is an optional extra from the supplier. Never use un-regulated AC/DC adaptor with higher rating than 3V D.C 100mA.

·        Do not attempt to open up the device and repair it yourself

·        Do not use in wet environment